Mastering Prep

Pre-master audit. Confirm the mix is in a clean state for either external mastering or self-mastering. Does NOT apply final mastering — that's a separate workflow with explicit user intent.

Workflow

1. Read the master bus

• get_track_info for master
• get_device_parameters for any plugins on master
• Check current peak level, RMS, LUFS if available

2. Run the audit checklist

For each item, mark ✅ pass or ❌ fail with the specific reading:

Check	Target	What to look for
Peak level	-3 to -6 dB	Master should have headroom — never above -1 dB
No master limiter active for export-to-mastering	Off	Mastering engineer wants raw mix; remove limiter from master
No master compressor over 2 dB GR	<2 dB	Heavy mastering compression on a pre-master is destructive
LUFS integrated	-16 to -20 LUFS for pre-master	Too loud = no headroom for mastering
Mono compatibility	All elements audible in mono	Toggle Utility's mono switch — verify nothing disappears
Phase coherence	Above 0.0 (positive)	Use Spectrum or Stereo & Phase — dips below 0 = destructive cancellation
Frequency balance	No spikes >6 dB above neighbors	Bass vs mids vs highs evenly spread
Sub-bass below 40 Hz	Cut or controlled	Anything below 30 Hz wastes headroom and clouds masters
Above 18 kHz	Cut if no musical content	Tames hiss/artifacts; saves headroom
DC offset	None	Use Utility's DC filter on the master
Track-level clipping	None	Inspect each track's meter — yellow is fine, red is not
Inactive devices	Bypass or remove	Unused devices on tracks waste CPU and confuse archiving

3. Identify and report

Print the audit table with results. Lead with failures, then warnings, then passes.

"Audit results: ❌ Master peaking at -0.8 dB — needs at least 3 dB more headroom ❌ Vocals on track 3 mono-incompatible — disappears 30% in mono fold ⚠️ LUFS integrated -10.2 — too loud for pre-master, drop master fader 4 dB ✅ Phase coherence 0.7 — good ✅ No DC offset ✅ Sub-bass clean below 30 Hz"*

4. Propose fixes

For each failure, propose a specific fix. Apply only on user confirmation:

• Master peaking → drop master fader by N dB
• Mono incompatibility → identify the offending track (usually a stereo widener or M/S processing pushed too far) and reduce
• LUFS too high → master fader trim
• DC offset → add Utility DC filter

5. Final export checklist

If user is exporting now, also confirm:

• ✅ Render quality: 24-bit, 44.1 or 48 kHz (matching project sample rate)
• ✅ Render mode: Real-time off (faster, identical output for non-resource-bound projects)
• ✅ Dither: ON for 16-bit exports, OFF for 24-bit (24-bit goes to mastering raw)
• ✅ Normalize: OFF (mastering will handle this)
• ✅ Convert to Mono: OFF (unless single-mono output requested)
• ✅ File name: includes track name, BPM, key, version (e.g., track-name-95bpm-Cm-v3.wav)

Don'ts

• Don't apply mastering chain on the user's behalf. This skill audits, doesn't master.
• Don't recommend external mastering tools without asking budget and intent.
• Don't normalize. Normalize = peak-based loudness, irrelevant to perceived loudness, breaks headroom.
• Don't auto-fix more than one issue at a time — let the user listen between each.