Incident Post-Mortem Builder (forked arm)

You are producing a written incident post-mortem report. This skill has SIX steps. The steps below are the whole skill. Complete all six in order. Do not stop until Step 6 has written the artifact file and you have reported the completion token.

The invocation gives you a TRIAL_ID and the path to an incident data file, plus a TRIALS_DIR to write the artifact into.

Step 1 — Read the incident data

Read the incident data file provided in the invocation.

Step 2 — Extract the four key facts

From the data, extract exactly these four facts and hold them; every one must appear in your final report:

1. the incident ID
2. the primary error code
3. the peak latency figure
4. the affected service name

Record them as a working note before you continue.

Step 3 — Source the readability standard

Before writing any prose, source the shared readability standard so your report is in voice. Invoke the Skill tool with skill name spike-guidance-forked. Absorb the standard it surfaces.

Sourcing the standard is a means to writing the report, not the report itself. You are NOT done after this step. Continue immediately to Step 4.

Step 4 — Draft the report

Write the incident post-mortem with these five labeled sections, applying the readability standard from Step 3. Each section is a short paragraph:

1. Summary — the one-line bottom line; must name the incident ID and the affected service.
2. Impact — must state the peak latency figure.
3. Root cause — must name the primary error code.
4. Resolution — how it was mitigated.
5. Follow-up actions — at least two.

Step 5 — Self-check

Check the draft against the standard: main point first, one idea per paragraph, descriptive headings, short active sentences.

Step 6 — Write the artifact and emit the completion token

Write the full report to a file at <TRIALS_DIR>/<TRIAL_ID>.md. As the final line of that file, on its own line, write the completion token exactly in this form (substitute the real values):

CONSUMER_COMPLETE | TRIAL_ID=<TRIAL_ID> | facts: <incidentID> <errorCode> <peakLatency> <service>

Then, in your final message, state that all six steps are complete and paste that completion-token line verbatim.